menu

Fitting & Care - Instructions


Fitting Instructions for Black DuckTM canvas seat covers

Fitting Instructions:

  • Remove each component from packaging
  • Check you have covers for seat, back, headrest & arm rest if applicable
  • Each piece is identified on the inside with the product code and a “D” for drivers seat or a ‘P’ for passenger seat
  • Put all drivers pieces aside
  • You should be left with all passenger pieces

Fitting Back:

  • Remove headrest if necessary
  • Slide cover over top of seat back and down
  • Replace headrest before sliding cover all the way down
  • Cover should be a good tight fit
  • Take front bottom flap and push through seat to rear
  • Pull tight and attach to Velcro inside rear of cover

Fitting Base:

  • Slide seat base onto seat ensuring it is clear of all levers or buttons
  • Push rear flap through seat to back
  • Pull both side flaps tight around seat base, ensuring clear of levers etc.
  • Attach to centre flap with the attached Velcro
  • If included, pull straps through under seat clearing all tracks and fittings. Pull tight and fasten to opposite side - Test movement of seat to ensure nothing is obstructed
  • As you use you vehicle, Black Duck™ Seatcovers will mould to the shape of your seats
  • You may find you need to re-tension the Velcro fasteners occasionally
  • Then proceed to fit Driver’s cover and rear seats if applicable

WARNING

Black DuckTM Canvas Seat covers must not be fitted to sets containing side impact airbag components. Only those Black Duck seat covers that are clearly labelled as being air bag compatible should be fitted to those vehicles with seat mounted air bags. Black DuckTM Canvas Products accepts no responsibility or liability if this warning is not adhered to.

Care instructions for Black DuckTM canvas seat covers

Care Instructions:

Your Black Duck™Canvas Seatcovers will stop anything from penetrating through to your vehicle seat. All dirt will be on the outside only.

  • Vacuum to remove all dust & lose dirt
  • Remove from seats
  • Use cold running water and a soft bristle brush
  • Run the dirt off the seat covers to avoid contaminating the clean side of the seat cover
  • Your seat cover may fade slightly after cleaning

Proofed polyester/cotton:

  • Do not dry-clean or machine wash
  • Warm hand wash only
  • May fade slightly after washing due to proofing process
  • May need reproofing to ensure water proofing